18 Nov 20
Hallway subfloor wood in pieces after leak repair on pipes. Approx 1m x 2m, needs to be replaced. Need to have battoning screwed to concrete floor so boards no rest directly on pipes. Then marine ply fitted. Location of problem is by front door, with secondary fire door right next to it. Ground floor flat.
06 Aug 20
Take down existing ceiling (including removal of existing resilient bars), install new soundproofing on ceiling including: sound isolation clips, channels, rockwool, 2 layers of acoustic drywall with MLV. Seal edges with acoustic sealent. Also worried about noise passing through walls, so would be happy to discuss possible treatments for that.
19 Jun 20
To supply and install a suspended fire rated plasterboard ceiling throughout to comply with building regulations (200m approx); joints taped and filled to receive decoration upon completion. To allow for an access panel to the ceiling void and 40db rating sound above the 3 surgeries and decontamination room. Ceiling height to be kept maximum height as possible and all one level with downstand bulkheads around beams and ductwork where necessary. Generally floor to ceiling height to be 2400mm where possible keeping void above suspended ceiling below 800mm (ceiling height 3200mm at highest point) Supply and construct floor to ceiling stud wall partitions (as shown on plan) to include sound insulation to cavity. Joints taped and filled leaving ready to receive decorative finish upon completion. The partition walls to achieve minimum fire rating to comply with current fire regulations. To ensure columns present are boxed in as shown on plans. OPG room to have one layer of stud wall to Code 3 (1.32mm to BSEN12588 or BBA equivalent) lead plasterboard as shown on drawing provided by RPA (in purple). The three surgeries to have one layer of plasterboard as Knauf Safeboard from floor level to a height of 2.0m in areas marked on drawing approved by RPA (in orange). Provisions made in stud walls to accommodate doors as shown on layout plan. Vertical timber batons in three walls (surgeries) to support wall mounted x-ray units
11 Jun 20
New bathroom install needed. Job will require removal of existing toilet, bath and sink and installation of new toilet, bath and sink. We also need the floors and part of the wall tiled. The size of the floor is 5m squared and the tiles we need installing are 25cm x 25cm. The walls that need tiling are 12m squared in total (two walls) and the tiles to go on the walls are 15 x 90cm.
03 Sep 19
Hi, we are looking for someone to install a new bathroom in our flat and renew it completely, tiling the floor and walls. We need to replace the basin, toilet and bath, but no structural changes. The size of the bathroom is 3.5m2. Would it be possible to get a quote for this? The flat is in Battersea. Thank you Alfredo
16 Aug 19
Flat in wapping. We need a bunch of renovation works including. - Removal of partition wall in the kitchen - Installation of new alcove cupboards - Resurfacing of kitchen wall - Removal and refit of kitchen ceiling - Installation of new kitchen (units, appliances, tiling and electrics only - not countertops). The units come pre-built so are quick to install. - Installation of new lighting (1 in the kitchen over the kitchen island, 2 in the bedroom on the wall as bedside lights, 1 extra on the wall in the living room, and 1 above the living room on a very high ceiling) - Installation of two new electric radiators - Replacement of all light switches and sockets with brass ones - Removal of old electrical sockets (5 in total) and resurfacing of the wall behind it - Sanding and resurfacing of windowsill and fixing of holes beneath windowsill
10 Aug 19
Steel frame to replace loadbearing stud wall in victorian house. 1 new stud wall and lesser studwork to square up 2 rooms. New unvented cylinder and removal of redundant plumbing/reworking of some existing. New bathroomx2 (plumbing, electrics, tiling). Plumbing of new radiators and moving a few light fittings. Making good & plasterboard patching.